PURSUIT 22 KODIAK Instrukcja Właściciela Pobierz pdf (Strona 100)

22 KODIAK

14.2 Winterizing

Raw Water System

Completely drain the raw water systems. Disconnect all hoses and blow the water from the system.

Use only very low air pressure when doing this to prevent possible system damage. Because of the

check valve mechanism built in the raw water washdown and livewell pumps, blowing the lines

will not remove the water from that raw water pump. Remove the inlet and outlet hoses on the

pumps. Turn each pump on and allow it to pump out any remaining water....about a cupful. A

recommended alternative to the above-mentioned procedure is the use of commercially available

nontoxic, potable water system antifreeze. If potable water antifreeze is used, pour the mixture into

a pail and put the raw water intake lines into the solution. Run the pumps one at a time until the

antifreeze solution is visible at all raw water faucets and discharge fittings and drains. Be sure

antifreeze has flowed through all of the raw water drains.

For additional information, refer to the Raw Water System chapter.

Freshwater System (Optional)

The entire freshwater system must be completely drained. Disconnect all hoses, check valves, etc.

and blow all the water from the system. Make sure the freshwater tank is completely drained. Use

only very low air pressure when doing this to prevent possible system damage. Because of the

check valve mechanism built in the pump, blowing the lines will not remove the water from the

freshwater pump. Remove the inlet and outlet hoses on the pump. Turn the pump on and allow

it to pump out any remaining water....about a cupful. A recommended alternative to the above-

mentioned procedure is the use of commercially available non toxic, freshwater system antifreeze.

After draining the potable water tank and lines, pour the antifreeze mixture into the freshwater tank,

prime and operate the pump until the mixture flows from all freshwater faucets. Be sure to open

all freshwater faucets, including the freshwater spray head in the leaning post bait station sink.

Make sure antifreeze has flowed through all of the freshwater drains.

For additional information, refer to the Freshwater System chapter.

Bilge

Coat all metal components, wire busses, and connector plugs in the bilge with a protecting oil. It

is also important to protect all pumps, seacocks and steering components.

The bilge pump and bilge pump lines must be completely free of water and dried out when the boat

is laid-up for the winter in climates where freezing occurs. Compartments in the bilge that will not

drain completely should be pumped out and then sponged until completely free of water.

Dry the hull bilge and self-bailing cockpit troughs. Water freezing in these areas could cause

damage.

Portable Head

The portable head must be properly winterized by following the manufacturer’s winterizing

instructions in the portable head owner’s manual.

14-4

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 127 128

Brak uwag

PURSUIT 22 KODIAK Instrukcja Właściciela Strona 100